Satellite Wiki

User Tools

Site Tools

Trace:
en:plutotrx:config

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
en:plutotrx:config [2021/06/17 01:33]
dj0abr [Image size] 		en:plutotrx:config [2021/09/18 18:32]
dj0abr
Line 13: Line 13:
 To do this, click on "SETUP" {{:de:plutotrx:c2.png?30|}} in the lower right corner. The setup window will open: To do this, click on "SETUP" {{:de:plutotrx:c2.png?30|}} in the lower right corner. The setup window will open:
  
-{{:de:plutotrx:ss1en.png?900|}}+{{:de:plutotrx:trxsetupen.png?900|}}
  
 **Pluto:** the Pluto can be connected directly via USB cable, in this case select "local USB". **Pluto:** the Pluto can be connected directly via USB cable, in this case select "local USB".
Line 26: Line 26:
 Usually you will use a USB sound card, there are also comfortable headsets with integrated sound card. In the lists "Loudspeaker" and "Microphone" you select the suitable audio device. Usually you will use a USB sound card, there are also comfortable headsets with integrated sound card. In the lists "Loudspeaker" and "Microphone" you select the suitable audio device.
  
-//**Note about Raspberry-OS**: with this operating system a real chaos of audio devices is output. No matter what USB device you use, with Rasperry-OS you should always choose the top selection: "**Playback/Recording through pulseaudio sound server**".+//**Note about Raspberry-OS and Odroid-Ubuntu**: with this operating system a real chaos of audio devices is output. No matter what USB device you use, with Rasperry-OS you should always choose the top selection: "**Playback/Recording through pulseaudio sound server**".
  
 Then open the audio mixer via the button "MIXER" ("pavucontrol": is already installed) and do the assignment of the audio devices here. The volume can also be set here.  Then open the audio mixer via the button "MIXER" ("pavucontrol": is already installed) and do the assignment of the audio devices here. The volume can also be set here. 
Line 99: Line 99:
  
 to set the language of the user interface to set the language of the user interface
 +
 +==== QSO Auto Sync ====
 +
 +If this function is activated the following happens:
 +
 +If you click on a QSO track in the "upper" waterfall, the QO100 transceiver tries to push this signal into the listening range (0 - 3kHz). The catch range is approx. +/- 6kHz. 
 +
 +After 2 seconds this function switches off automatically.
 +
 +This works sometimes better and sometimes worse, after the auto adjust you can still make a fine adjustment.
 +==== PTT Mode ====
 +
 +Sets the behavior of the PTT, either key mode or toggle mode.
  
 ==== Image size ==== ==== Image size ====
en/plutotrx/config.txt ยท Last modified: 2021/09/18 18:32 by dj0abr

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki