en:plutotrx:operation
Differences
This shows you the differences between two versions of the page.
| Next revision Both sides next revision | |||
|
en:plutotrx:operation [2021/06/03 14:36] dj0abr created |
en:plutotrx:operation [2021/06/12 01:31] dj0abr |
||
|---|---|---|---|
| Line 38: | Line 38: | ||
| ==== other controls ==== | ==== other controls ==== | ||
| - | {{: | + | {{: |
| * RIT ... the mouse wheel changes the RX frequency | * RIT ... the mouse wheel changes the RX frequency | ||
| Line 53: | Line 53: | ||
| * RX and TX filters ... the bandwidth of the audio signal can be set separately for receive and transmit. For SSB QSOs the default setting is: RX = 3.6kHz and TX = 2.7kHz. | * RX and TX filters ... the bandwidth of the audio signal can be set separately for receive and transmit. For SSB QSOs the default setting is: RX = 3.6kHz and TX = 2.7kHz. | ||
| + | |||
| + | * TX Bass ... affects the frequency response of the TX audio signal, when enabled, more low frequencies can be heard. | ||
| * Audio Loop ... The audio signal of the microphone is switched directly to the speaker. This allows to check the correct function of microphone and speaker. | * Audio Loop ... The audio signal of the microphone is switched directly to the speaker. This allows to check the correct function of microphone and speaker. | ||
en/plutotrx/operation.txt ยท Last modified: 2021/09/18 18:44 by dj0abr
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
