en:plutotrx:operation
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | Next revision Both sides next revision | ||
|
en:plutotrx:operation [2021/06/28 15:56] dj0abr |
en:plutotrx:operation [2021/06/28 16:05] dj0abr |
||
|---|---|---|---|
| Line 77: | Line 77: | ||
| In addition to the volume setting, you have comfortable options for assigning audio devices. For example, you can switch the receive signal between the headphones or the speakers in the HDMI monitor without having to change the SETUP of the QO100 transceiver. | In addition to the volume setting, you have comfortable options for assigning audio devices. For example, you can switch the receive signal between the headphones or the speakers in the HDMI monitor without having to change the SETUP of the QO100 transceiver. | ||
| + | |||
| + | ==== Special functions ==== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | Screen icon ...setting of different screen resolutions to adapt the window to the monitor used. | ||
| + | |||
| + | CAL ... Menu for convenient setting of the correction values for the pluto and LNB reference frequency | ||
| + | |||
| + | LOCK/FREE ... Switching on and off the automatic beacon synchronization. When using a slow computer like Raspberry 3B+ the beacon synchronization must be switched off (FREE). | ||
| + | |||
| + | SAVE/LOAD ... Memory for the RX and TX frequency | ||
en/plutotrx/operation.txt ยท Last modified: 2021/09/18 18:44 by dj0abr
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
