This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
en:plutotrx:raspi [2021/06/09 13:09] dj0abr [Image] |
en:plutotrx:raspi [2021/06/28 15:16] dj0abr |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Raspberry PI Info ===== | ===== Raspberry PI Info ===== | ||
- | * at least a Raspi-4 is required. The RPI 3B+ is too slow | + | * a Raspi-4 is recommended. The RPI 3B+ goes from version 1.67 also quite well, but is of course a bit slower to use than the RPI4. |
- | * the Pluto can be connected via USB. Alternatively | + | * Raspberry OS 32bit is used (the 64bit version was not tested). |
+ | * the Pluto can be connected via USB or alternatively | ||
* tested Pluto versions: Rev.B, Rev.C with original software or with F5OEO software, as of 2019 or 2021. | * tested Pluto versions: Rev.B, Rev.C with original software or with F5OEO software, as of 2019 or 2021. | ||
Line 10: | Line 11: | ||
If you want to have a ready image for the SD card, you can get it here: | If you want to have a ready image for the SD card, you can get it here: | ||
+ | |||
+ | Version: V1.6 | ||
[[https:// | [[https:// | ||
- | Username: | + | Username: pi\\ |
- | Password: | + | Password: qo100trx |
- | Language | + | the SSH server is installed |
+ | The image is not always up to date. After installing this image you may have to update QO100_Transceiver, see here: [[en: | ||
- | the ssh server is installed and activated | ||
===== Power supply ===== | ===== Power supply ===== | ||