This shows you the differences between two versions of the page.
Both sides previous revision Previous revision | Next revision Both sides next revision | ||
en:plutotrx:raspi [2021/06/28 15:16] dj0abr |
en:plutotrx:raspi [2021/06/28 15:17] dj0abr |
||
---|---|---|---|
Line 3: | Line 3: | ||
===== Raspberry PI Info ===== | ===== Raspberry PI Info ===== | ||
- | * a Raspi-4 is recommended. The RPI 3B+ goes from version 1.67 also quite well, but is of course a bit slower | + | * a Raspi-4 is recommended. The RPI 3B+ works since version 1.67 also quite well, but is of course a bit slower than the RPI4. |
* Raspberry OS 32bit is used (the 64bit version was not tested). | * Raspberry OS 32bit is used (the 64bit version was not tested). | ||
* the Pluto can be connected via USB or alternatively via ETH/USB adapter, but the operation should then be done via Ethernet cable. The data rate is just under 20Mbit/s which is too fast for most wlans. | * the Pluto can be connected via USB or alternatively via ETH/USB adapter, but the operation should then be done via Ethernet cable. The data rate is just under 20Mbit/s which is too fast for most wlans. |