User Tools

Site Tools


en:plutotrx:raspi

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revision Both sides next revision
en:plutotrx:raspi [2021/06/28 15:16]
dj0abr
en:plutotrx:raspi [2021/06/28 19:41]
dj0abr
Line 3: Line 3:
 ===== Raspberry PI Info ===== ===== Raspberry PI Info =====
  
-  * a Raspi-4 is recommended. The RPI 3B+ goes from version 1.67 also quite well, but is of course a bit slower to use than the RPI4.+  * a Raspi-4 is recommended. The RPI 3B+ works since version 1.67 also quite well, but is of course a bit slower than the RPI4.
   * Raspberry OS 32bit is used (the 64bit version was not tested).   * Raspberry OS 32bit is used (the 64bit version was not tested).
   * the Pluto can be connected via USB or alternatively via ETH/USB adapter, but the operation should then be done via Ethernet cable. The data rate is just under 20Mbit/s which is too fast for most wlans.   * the Pluto can be connected via USB or alternatively via ETH/USB adapter, but the operation should then be done via Ethernet cable. The data rate is just under 20Mbit/s which is too fast for most wlans.
Line 48: Line 48:
 cd QO100_Transceiver cd QO100_Transceiver
 ./prepare_ubuntu_pluto ./prepare_ubuntu_pluto
 +./prepare_raspi
 ./install ./install
 </code> </code>
en/plutotrx/raspi.txt ยท Last modified: 2021/08/30 18:58 by dj0abr