en:upconverter:up_serial
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision | |||
|
en:upconverter:up_serial [2021/08/27 01:20] dj0abr [serial data format] |
en:upconverter:up_serial [2023/02/25 16:28] (current) dd1us [Downconverter message pass-through:] |
||
|---|---|---|---|
| Line 65: | Line 65: | ||
| The serial output of the downconverter is connected to the serial input of the upconverter. The serial output of the upconverter is connected to a computer via a 3.3V-RS232 level converter. In the computer you can then read all messages. The messages of the downconverter start with header " | The serial output of the downconverter is connected to the serial input of the upconverter. The serial output of the upconverter is connected to a computer via a 3.3V-RS232 level converter. In the computer you can then read all messages. The messages of the downconverter start with header " | ||
| + | Please note that due to a layout bug in the board revisions 4.2 and before a special workaround was needed. | ||
| + | This was corrected in board revision 4.3. | ||
| ==== Evaluation of the forward power: ==== | ==== Evaluation of the forward power: ==== | ||
en/upconverter/up_serial.txt ยท Last modified: 2023/02/25 16:28 by dd1us
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
