This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
en:hsmodem:installlinux [2021/03/28 19:14] 127.0.0.1 external edit |
en:hsmodem:installlinux [2022/05/16 01:02] dj0abr |
||
---|---|---|---|
Line 1: | Line 1: | ||
====== Installation ====== | ====== Installation ====== | ||
- | The installation files are located here: \\ | ||
- | [[https:// | ||
- | |||
===== Linux ===== | ===== Linux ===== | ||
- | There are ready-made images for the single-board computers Raspberry PI 4, Odroid N2 and Odroid C4. After the download, you write this on an SD card and boot the SBC. Afterwards you can expand the partition size to the maximum size of the SD card (see command: resize2fs). | + | from Github |
- | + | and save it to any directory on the Linux PC (e.g. the home directory). | |
- | The images contain fully tested HS modems | + | |
- | + | ||
- | ===== Linux Github ===== | + | |
- | + | ||
- | Hsmodem is an open source project. All files can be downloaded here: \\ | + | |
- | [[https:// | + | |
- | The README.md file contains information on compiling and installing. | + | |
- | ===== Installation from the current Github sources ===== | + | Example to load the file: |
- | only load this one file from Github: ** hsmodem.sh | + | wget https:// |
- | Save in any directory on the Linux PC (e.g. in the home directory) \\ | + | Make the file executable: |
- | Make the file executable: | + | |
- | and start the file: **. / hsmodem.sh | + | and start the file |
+ | | ||
- | The system | + | The system |
- | HSmodem requires a reasonably | + | HSmodem requires a reasonably |
- | === Attention: === | + | === Note: === |
- | GLIBC Version | + | GLIBC version |