Differences

This shows you the differences between two versions of the page.

--- en:plutotrx:operation [2021/06/28 15:56]
dj0abr
+++ en:plutotrx:operation [2021/09/18 18:39]
dj0abr
@@ Line 51: / Line 51: @@
   * T>R ... the TX frequency is copied to the RX frequency
-  * AGC ... increases the volume when speaking softly and decreases the volume when speaking very loudly. The AGC is always recommended, it can also avoid the "Leila" response when speaking very loud for a short time.
+  * AUDIO ... opens a window with settings for the microphone sensitivity (Mic-Boost should be set to 1 at first. Only if the sound is too quiet you can turn it up) and a bass boost. The bass boost is needed for electret microphones which deliver only little bass.
   * MUTE ... reduces the volume in headphones or loudspeaker while transmitting. So you are no longer disturbed by listening back. Quietly one hears oneself for control purposes still.
@@ Line 77: / Line 77: @@
 In addition to the volume setting, you have comfortable options for assigning audio devices. For example, you can switch the receive signal between the headphones or the speakers in the HDMI monitor without having to change the SETUP of the QO100 transceiver.
+==== Special functions ====
+{{:de:plutotrx:sb1a.png?40 |}}
+Screen icon ...setting of different screen resolutions to adapt the window to the monitor used.
+CAL ... Menu for convenient setting of the correction values for the pluto and LNB reference frequency
+LOCK/FREE ... Switching on and off the automatic beacon synchronization. When using a slow computer like Raspberry 3B+ the beacon synchronization must be switched off (FREE).
+SAVE/LOAD ... Memory for the RX and TX frequency

Satellite Wiki

User Tools

Site Tools

Differences

Page Tools