en:upconverter:up_serial
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision Last revision Both sides next revision | ||
|
en:upconverter:up_serial [2021/08/27 01:19] dj0abr created |
en:upconverter:up_serial [2021/08/27 01:20] dj0abr [serial data format] |
||
|---|---|---|---|
| Line 6: | Line 6: | ||
| The Amsat upconverter version-4.2 has a serial interface on a 6-pin header near the LED row. Diagnostic messages and measured values are output here: | The Amsat upconverter version-4.2 has a serial interface on a 6-pin header near the LED row. Diagnostic messages and measured values are output here: | ||
| - | **Level:** 3,3 Volt (for connection to a RS232 interface a 3,3V - RS232 converter is UNCONDITIONALLY required !) | + | **Level:** 3,3 Volt (for connection to a RS232 interface a 3,3V - RS232 converter is UNCONDITIONALLY required !)\\ |
| - | **baud rate:** 9600 Bd | + | **baud rate:** 9600 Bd\\ |
| - | **Data bits:** 8 | + | **Data bits:** 8\\ |
| - | **stop bits:** 1 | + | **stop bits:** 1\\ |
| **parity:** none | **parity:** none | ||
| Line 22: | Line 22: | ||
| terminated with newline. | terminated with newline. | ||
| - | **It means | + | **in detail** |
| UPC ... 3 characters header to indicate that display content follows. Lines not starting with UPC can be ignored. | UPC ... 3 characters header to indicate that display content follows. Lines not starting with UPC can be ignored. | ||
en/upconverter/up_serial.txt · Last modified: 2023/02/25 16:28 by dd1us
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
